Hi learned ones
I`ve discovered the reason the last man got shut of my R12, it has an oil weep from the LH cylinder barrel, only takes 10 miles or so and you can see oil drops on the btm of the frame and exhaust where its been blown, the leak is from the bottom of the cylinder barrel itself, between the two bottom bolts.
So, presuming this will be crazy expensive at a dealer, I`m about to learn how to strip down the cylinder...
Any one with experience of doing this? I`m open to any advice...
And the numpty question, do I have to drain the oil to do this, the sight glass is below the level of the bottom of the cylinder, doesn`t mean the oil level will be lower...? ( I`m not that tight but the oil and filter were only changed a 100 miles ago)
cheers
R1200s Cylinder oil leak - numpty question!
Moderators: Gromit, Paul, slparry
Re: R1200s Cylinder oil leak - numpty question!
Phil.
R1200S and loving it !
Hoch Bergstraßenjäger…………………………………
R1200S and loving it !
Hoch Bergstraßenjäger…………………………………
Re: R1200s Cylinder oil leak - numpty question!
Excellent...
Thank you very much for that, I`ll give that a good watch later....when she`s got corrie on
cheers
Thank you very much for that, I`ll give that a good watch later....when she`s got corrie on
cheers
Re: R1200s Cylinder oil leak - numpty question!
Just for info:
Answer to `numpty question` is no, a small amount is lost taking head / cylinder off etc but nothing significant, barely affects oil level.
For anyone having to do this, ( cylinder removal ) its a relatively straight forward job if a little time consuming first time round, 2nd time I did it was alot quicker...don`t ask
Main lesson learnt, removing cylinder leaving piston in place is ok but fiddly getting barrel back on and rings to line up without damaging the oil control spring, much better to withdraw barrel just enough to disconnect piston from con rod and remove with piston still in barrel, reassemble using a ring compression tool and dropping piston back into barrel then sliding back into place onto the rod etc.
Oil weep was from a failed blanking plug, not failed sealant as first thought, so replacement cylinder barrel fitted and bike is now how it should be and after a few miles I`m seriously back in love with it....what a fantastic bike these are
seasons greetings to all
cheers H
Answer to `numpty question` is no, a small amount is lost taking head / cylinder off etc but nothing significant, barely affects oil level.
For anyone having to do this, ( cylinder removal ) its a relatively straight forward job if a little time consuming first time round, 2nd time I did it was alot quicker...don`t ask
Main lesson learnt, removing cylinder leaving piston in place is ok but fiddly getting barrel back on and rings to line up without damaging the oil control spring, much better to withdraw barrel just enough to disconnect piston from con rod and remove with piston still in barrel, reassemble using a ring compression tool and dropping piston back into barrel then sliding back into place onto the rod etc.
Oil weep was from a failed blanking plug, not failed sealant as first thought, so replacement cylinder barrel fitted and bike is now how it should be and after a few miles I`m seriously back in love with it....what a fantastic bike these are
seasons greetings to all
cheers H
Re: R1200s Cylinder oil leak - numpty question!
Well done Hayden, glad you’re enjoying the 12s
Merry Christmas
Merry Christmas
Phil.
R1200S and loving it !
Hoch Bergstraßenjäger…………………………………
R1200S and loving it !
Hoch Bergstraßenjäger…………………………………
Who is online
Users browsing this forum: No registered users and 151 guests