Hello again. I hope you are all wonderful.
Trying to resurrect my old R1100S. I pulled the tank off and it looks like the previous owner had jammed in a 896 Lawnmower battery. after judicious hammertime of the battery tray. I ordered a similar replacement (Very Very Cheap) but it is frighteningly close to the bottom of the fuel tank.
Bike Starts and runs OK, But I suspect my input shaft Is on its way out. (rattly noise).
What is the correct battery for this bike? Motobatt 51814?
I need to decide whether to save or break it, as it has a set of remus pipes.
Cheers
Battery for early R1100S
Moderators: Gromit, Paul, slparry
Re: Battery for early R1100S
If the 896 is doing the job I'd just cover it ( the terminals ) with a piece of old inner tube to insulate it.... Other than that does your bike have Abs ? If so you'll need a 19 or 20A/h battery.
I've used a locally purchased Platinum ctm19lbs AGM battery which I laid on its side after modifying the battery box , (Abs removed)
I think I tried something similar to a 51814 a while back but it didn't turn over the engine very well ... I've since replaced the starter motor so maybe that was the problem?
I've used a locally purchased Platinum ctm19lbs AGM battery which I laid on its side after modifying the battery box , (Abs removed)
I think I tried something similar to a 51814 a while back but it didn't turn over the engine very well ... I've since replaced the starter motor so maybe that was the problem?
_________________
Nigel
Keep smiling, it makes people wonder what you've been up to!
1999 R1100s (mandarin) '
2018 DL 250V Strom
2019 CB125F Honda.
MZ301 Saxon Fun ( currently retired)
'03 Bullet 65 project..
Nigel
Keep smiling, it makes people wonder what you've been up to!
1999 R1100s (mandarin) '
2018 DL 250V Strom
2019 CB125F Honda.
MZ301 Saxon Fun ( currently retired)
'03 Bullet 65 project..
Re: Battery for early R1100S
Thank you.
I'll line everything up tomorrow. The bike has been sitting for 4 1/2 years so I need to bleed the brakes and do a bunch of other stuff before I take for MOT/ decide whether to part it out.
It's a non ABS model.
I'll line everything up tomorrow. The bike has been sitting for 4 1/2 years so I need to bleed the brakes and do a bunch of other stuff before I take for MOT/ decide whether to part it out.
It's a non ABS model.
Gary
Re: Battery for early R1100S
Bought the exide battery in the end. Bike is back together.
Thanks for the input.
Thanks for the input.
Gary
Who is online
Users browsing this forum: No registered users and 28 guests