R1200S Front Brake light switch

saabowl · Post by **saabowl** » Tue Nov 06, 2012 6:18 pm

Hi,

My brake light is not working, but can do when I fiddle with the switch. I hear there is a 2mm hex bolt that you can loosen, get it in place, then tighten.

Is this bolt adjustable in situ or does the brake assembly have to be removed?

Any ideas gratefully received .

Mark[/url]

Droptarotter · Post by **Droptarotter** » Wed Nov 07, 2012 5:35 am

There is a very small grub screw under the lever. If you loosen it, you can adjust the brake light switch.
Be careful if you take out the switch as there is a small "T" that the grub screw pushes on and that will end up in the far reaches of the garage.

You can also use the clutch switch for testing as both switches are the same.

Cheers

saabowl · Post by **saabowl** » Wed Nov 07, 2012 6:00 am

Thanks for getting back,

I'll give it a go

Mark