Page 1 of 1
Can U fix it ?
Posted: Mon Jul 19, 2004 5:50 pm
by vienna
1)I have Touratech mount for GPS but instructions are in German!
What if anything do I need to take off before fitting
2) Also have Ventura rack from e bay, no instructions, will it go on with pannier frames and what does it fit too,thought it would be obvious, but I must be thick!
Posted: Mon Jul 19, 2004 5:55 pm
by Rob B
Re Touratech mount, have you got the one that straps across the yoke. If so, it's a good idea to wrap the bolt threads to stop yoke scratches.
Oh yes, ign key will be a struggle.
Rgds,
Rob
Re: Can U fix it ?
Posted: Mon Jul 19, 2004 7:47 pm
by Jason M
2) Also have Ventura rack from e bay, no instructions, will it go on with pannier frames and what does it fit too,thought it would be obvious, but I must be thick![/quote]
To fit the Ventura you need to remove the two rear 3/4 panels first. Then it should be obvious which bolt to remove - 5/6mm hex up near the back in the tail fairing (for the vertical fixing). The other should then fall into place - but its the 10mm bolt under the riders thigh in the rear subframe
Any problems - gimme a shout and I might be able to post you some pics
good luck
Jason
Posted: Mon Jul 19, 2004 7:55 pm
by boxerpan
Vienna,
do you have a fax number that I can send the instruction sheet for Ventura to
Lloyd
Posted: Mon Jul 19, 2004 8:40 pm
by Boxertools
My touratech mount which I think is the same as Rob's, fits to the S with a seperate adapter bracket which is powder coated silver.
Fit the adapter to the yoke (protect the yoke) then fit the perforated ally mount.
Mike.
Posted: Mon Jul 19, 2004 9:23 pm
by vienna
I have adaptor bracket and 2 screws, but can't see how it fits to yoke, do you have to remove yoke to fit it?
Posted: Wed Jul 21, 2004 6:45 pm
by Ade B
I have the instructions for the Ventura luggage rack kicking around somewhere, could scan em and email if you require it.
Should be straight forward, just don't tighten anything up until its all in place.
Ade