Silly question I know but...............

Dog Tyred · Post by **Dog Tyred** » Tue Oct 03, 2006 12:47 pm

Are the cylinder head covers of a standard single spark S the same as the single spark Boxercup Rep covers? i.e can you fit the original carbon head covers on to a standard S without changing the cylinder head covers themselves?

cheers

Nu2

sandbar · Post by **sandbar** » Tue Oct 03, 2006 6:54 pm

No!!

sandbar

Dog Tyred · Post by **Dog Tyred** » Wed Oct 04, 2006 7:46 am

so thats a No then?

madman · Post by **madman** » Wed Oct 04, 2006 7:56 am

Yes, it is a no. To clarify the bolt positions are different from twin to single sparg, but you can get the covers for both.

sandbar · Post by **sandbar** » Wed Oct 04, 2006 8:16 am

madman wrote:Yes, it is a no.

The rocker cover (not magnesium but alloy) for the single spark BCR has got two threaded holes for the screws that hold the carbon cover in place. Those holes are not present on the normal 1100S magnesium covers.

Of course you could drill and tap holes in your magnesium covers, but I don't think that the covers are thick enough for a 'blind' hole, so then you would have to find a way of sealing them.

sandbar

Dog Tyred · Post by **Dog Tyred** » Wed Oct 04, 2006 1:00 pm

No, no, not necessary as I have a BCR already.

Needed to know for another reason