Best Stripper?

Harry Lime · Post by **Harry Lime** » Fri Dec 20, 2013 11:01 am

Deleted.

McBoxer · Post by **McBoxer** » Fri Dec 20, 2013 12:01 pm

After reading the title and first few lines, I had a whole range of recommendations for you. However, on reading further I realised that you were after a different kind of stripper altogether

So, in order to do that single malt some justice; fire up the log burner, pour yourself a large dram, sit back in a comfy arm chair with your feet up - and send the parts off to someone else.
You know it makes sense!

Merecat · Post by **Merecat** » Fri Dec 20, 2013 12:05 pm

Nitromors Is your friend here.
Splosh it on and scrub it off with a stiff brush.

Corvus · Post by **Corvus** » Fri Dec 20, 2013 12:13 pm

McBoxer wrote:After reading the title and first few lines, I had a whole range of recommendations for you. However, on reading further I realised that you were after a different kind of stripper altogether
.........D

Yes, I expect this thread will have a high view hit rate!

eyore · Post by **eyore** » Fri Dec 20, 2013 1:09 pm

Merecat wrote:Nitromors Is your friend here.
.

Only if it lands where its intended to do so..................otherwise its your enemy.

And don't imbibe till the job is done.

Bikerhoss · Post by **Bikerhoss** » Fri Dec 20, 2013 1:46 pm

Fine sanding disk/pad/brush and an angle grinder

and that IS how I did mine

actually gave quite a good even finish if you were of the polishing mind

Boxadog 2000 · Post by **Boxadog 2000** » Fri Dec 20, 2013 6:59 pm

Merecat wrote:Nitromors Is your friend here.
Splosh it on and scrub it off with a stiff brush.

Nitromores and ally do not mix well.

Get a specific stripper for ally or just Vapor blast which is a really nice finish for ally.

Then spray with clear lacquer it will be a finish that you will be impressed with.

tanneman · Post by **tanneman** » Fri Dec 20, 2013 9:50 pm

I had mine bead blasted to get rid of the paint in the most inaccessible places. The surface finish is rough as manufactured so a fair bit of polishing is going to happen. I painted mine by the way.