Missing Post

The Teutonic Tangerine · Tue Sep 03, 2013 11:58 am

I have lost a post: The post Where I asked about thje Bevel Box oil seal on an R1200 Bevel Box. I am still hoping someone can tell me how to remove the Black plastic annular (ring) cover as I don't want to fudge it.

Cheers

Blackal · Post by **Blackal** » Tue Sep 03, 2013 12:17 pm

It got nuked..........

It developed into a big argument, then a flounce.

Al

conkerman · Post by **conkerman** » Tue Sep 03, 2013 12:40 pm

Hehe.

Flounce.

I love that word.

Corvus · Post by **Corvus** » Tue Sep 03, 2013 2:08 pm

Hee Hee. I'd forgotten that it all started with a genuine request! Was too busy dodging the muck n bullets.

Mainly muck.

herrman · Post by **herrman** » Tue Sep 03, 2013 8:44 pm

Hi,
Had to do this on my 12s last year, If I recall correctly the plastic (??) retaining ring just pops out with a small screwdriver, Destroy the old seal with a seal puller and pull out and drive the new seal in. I made a tool at work to push the new seal in --Short piece of 76mm pipe which I had to linish down slightly and away you go.

Peter.

boxerscott · Post by **boxerscott** » Wed Sep 04, 2013 12:21 am

There you go, experience and knowledge dispensed in a cordial and polite manner!

bikesnbones · Post by **bikesnbones** » Wed Sep 04, 2013 7:13 am

boxerscott wrote:There you go, experience and knowledge dispensed in a cordial and polite manner!

The Teutonic Tangerine · Thu Sep 05, 2013 1:47 pm

Thanks - by the time flouncing stopped so had the leak.