Exhaust refinishing

bikesnbones · Post by **bikesnbones** » Sat Aug 10, 2013 9:22 pm

Anyone here had any experience of powder coating exhausts ?
Is it even possible ?

Boxered · Post by **Boxered** » Sat Aug 10, 2013 9:28 pm

Not sure about powder coating, but this company in Warrington does ceramic coating

http://camcoat.com/main/site/

Steve

bikesnbones · Post by **bikesnbones** » Sun Aug 11, 2013 3:05 am

Thanks.
Probably very expensive but I'll look into it.

tanneman · Post by **tanneman** » Sun Aug 11, 2013 10:25 am

Generally they don't ceramic coat used exhaust systems because they cannot guarantee the finish.

dave the german · Post by **dave the german** » Sun Aug 11, 2013 12:21 pm

Calling daveg2812 to the forum - dave had his coated. Have a look at the results. He did have pics up

adrianw · Post by **adrianw** » Sun Aug 11, 2013 4:28 pm

http://www.zircotec.com/

A friend of mine just got his TERMIGNONIs done on his 916SPS

The company is a spinoff from the nuclear industry.

Good for up to 900 degrees.

Adrian

Daveg2812 · Post by **Daveg2812** » Thu Aug 15, 2013 11:47 am

Mine were done at Camcoat in Warrington using their Cermakrome product.

And on the bike,

Bike's not had a lot of use this year but the finish is still pretty much the same. Cost about £150 (ish) with carriage.

oyster · Post by **oyster** » Fri Aug 16, 2013 3:06 pm

Mine looked just like Dave's when I had then ceramic coated. Cerachrome outside, black ceramic inside. On used pipes. They got sandblasted before the coating. Now, the finish is like dull alloy, old Triumph or Norton cases.