R1200S Black Double Bubble Screen?

Copper · Post by **Copper** » Fri Feb 22, 2013 4:30 pm

Hi,

The only one I have seen is a Puig one on ebay for 67 quid.

Is that my only option?

Regards,

Jon

madthemad · Post by **madthemad** » Fri Feb 22, 2013 5:20 pm

Go to Links at top of page and visit MV Motorrad Technik. That's where I got mine from. And cheaper than UK.

gus · Post by **gus** » Sat Feb 23, 2013 7:26 pm

Hi
I have a MRA double bubble screen on mine. HPS stock them.£51.
Gus

Copper · Post by **Copper** » Sun Apr 07, 2013 8:35 am

Thanks!

Jon

ted · Post by **ted** » Sun Apr 07, 2013 9:53 am

i had a Puig one and it split after a couple of rides and looking on the net it isnt an isolated case. Looked good but mine seemed too small for the aperture which meant that it had to be stretched slightly to get it to fit - i suspected that was the issue

Gromit · Post by **Gromit** » Sun Apr 07, 2013 10:00 am

ted wrote:i had a Puig one and it split after a couple of rides and looking on the net it isnt an isolated case. Looked good bur mine seemed too small for the aperture which meant that it had to be stretched slightly to get it to fit - i suspected that was the issue

Not surprising really - putting plastic into a stressed position (as you clearly had no choice but to do) and then subjecting it to the boxer engine's vibrations it was bound to give in at some point.

The MRA one that Gus suggested would be my choice.

StreetFlatTwin · Post by **StreetFlatTwin** » Sun Apr 07, 2013 8:31 pm

I think the Puig screens cracking were the early ones as there are quite a few on here-myself included who have one without problems.
Good quality and fit and looks great!!