Kawasaki ZRX1200R
2001 Y plate
18,500 miles
£4500 ono
Very Good Condition
Bridgestone BT023 tyres with approx 2.5k on them.
It comes with a genuine Tony Archer modified seat 'and' a cut down original.
The bike can be viewed in Beaconsfield, Bucks. drop me a line if interested.
Cheers
Steve
"Just had new MOT this week & a Full service including brake overhauls 2.5k ago.
Suspension Work Carried Out By Ross at : http://www.moto-pro.co.uk/
All Engineering Work Carried Out By Two Wheel Engineering at : http://www.motorcycledynobridgend.co.uk/
(They carry many photos of the work undertaken on this bike)
The bike is Dyno’d at 129BHP
The bike is serviced annually by a HD / Kawasaki trained mechanic
He currently works at Pembray Racing Circuit fine tuning Race Bikes
Front End
ZX9B2 USD Forks with KTech Internals fitted and serviced by Ohlins & KTech trained suspension technician.
Nissin 4 Pots GSXR fitment (much improved over OE Tokiko 6 pots)
Custom made calliper carriers
HEL Braided Brake & Clutch lines throughout.
Top Yoke Modded ZXR750 to retain correct steering geometry
Bottom Yoke Modded ZX9B2 to retain correct steering geometry
Steering Stem is Original ZRX press fitted
Renthal ultra low Bars & Risers fitted with Renthal grips
Bodywork/Frame
Custom Frame Bungs
R&G Racing Crash Bungs (Black)
Custom Braided Oil Lines x2
Engine Casings now all black and not bronze
Radiator Brackets now all black not chromed
K&N Oil Breather/Crankcase Filter x 1
Ted 383’s Fender Eliminator Kit (removes end of long rear mudguard & makes back end sexy)
Ted 383’s Horn relocation bracket (under cowl)
LED clock illumination (green)
Air Box / Carburettors
Ivan’s Stage 3 Needles and Jets
Ivan’s Block Off Plates (after emissions octopus is removed this covers rocker cover reed ports)
K&N Filters x 4
Ted 383’s Battery Out Kit (under seat conversion you should get a gallon container in there with no problem with the seat fully in place
Exhaust
Full Akrapovic Road Legal System E stamped approved for road use .Stainless down pipes and Titanium Can (removable baffle under seat)
Timing
KWICK’s, 4 degree ignition advancer (with KTric disconnected)
Safety
KWICK’s, KWICK KILL : Tip Over engine protection Kill Switch (fitted under tank)
KWICK’s, TENSIONER TAMER: stops tensioner arm hitting the clutch hub and marking/damaging it
Rolands Lighting Harness Mod: gives full voltage to headlamp bulbs increase brightness by 40%
Back End
JMC custom ZRX deep braced swingarm
ZXR 750 6 INCH Rear Wheel
ZXR 750 sprocket carrier, calliper carrier: OE Brake Calliper
Galfer Wavey Disk: ZXR 750 fitment
TALON Engineering Gold Chain & Sprockets: ZXR 750 fitment
OHLINS 36PRCLB KA702 : fully adjustable including height (fully serviced by suspension tech as above)
IMG_2071 by steve, on Flickr
IMG_2065 by steve, on Flickr
IMG_2069 by steve, on Flickr
IMG_2072 by steve, on FlickrThis one is a video.. Should take you to my Flickr page.
IMG_2080 by steve, on Flickr