Rear Wheel Nuts

[Boxermed69]

[quote="Viscount you stop making the dodgy puns they all sound like a load of Velox?"[/quote]

Ooooh, back o' the net

Mike

[dave the german]

cheers Steve I want some stuff from Motorworks so will add it to the list

[Dai wiskers]

Mine turned up today can you imagen[spelin i tried to spell that word about a dozen times and it still not look right dam easy sounding words are the hardest] how gutted i was they not silver they dark grey!!!

Look good though

[dave the german]

I was looking on tinternet other day for some wheel nut covers - found a site called Performance Alloys ( I think but google wheel nut covers and you will find it) set of 20 covers in either chrome or black chrome - well cheap but cannot remember the price!! bout 15 squidish and includes a tool to remove them (although it looks flimsy)

[Al]

I got mine from a guy on here, must have been in 2006 just after I got the bike. It is machined in ally with an O ring on it to make it a positive fit.
I think Boxer Design & Wunderlich do them as well.

Al.

[D Man]

Covers off a VW Jetta will fit nicely as well...
D Man

[Nookiebear]

.

Nuts Covered.

Love this cover, did you make it yourself?

[el-nicko]

Love this cover, did you make it yourself?

'fraid not mate. Was on the bike when I bought it. I agree it is nice and it acts as quite a good anti-theft device. To remove the wheel you have to prize out the recessed badge which is attached by velcro.There's an almost invisible slot where you can just insert a small screwdriver. Underneath there is a cap-screw that has to be removed before the cover can be removed to expose the wheel nuts. Perhaps a fellow trixter will recognise it and can tell us more?

[Dai wiskers]

I'm wondering if it's the centre from a car alloy

[Boxered]

It is very similar, but not quite the same as the one I had on my old 11S, I bought mine from streetfighters.com via ebay, they had about 5 of them only, and were a one off production run ( not enough interest apparently )
I sold mine on to Ruffy, don't know if he still has it?

Steve

[Dai wiskers]

This type of thing
http://www.ebay.co.uk/itm/BMW-Alloy-Whe ... 257a18a1be

Measure before you buy i have not checked size

[el-nicko]

I see what you mean Dai. Mine has quite a long(1.5"?), hollow boss in the centre that fits into the middle of the wheel.

[Dai wiskers]

All the ones i looked at have been too big but a BMW badge on another make may be what it is

Then again it's probably bespoke as it's quite possibly easier to make one from scratch than bodge one to fit