R1100's front brake judder

Got a technical query? Found another 0.02bhp? Ask/tell the world.

Moderators: Gromit, Paul, slparry

Post Reply
gismo
Posts: 5
Joined: Fri Oct 19, 2007 1:44 pm
Location: France

R1100's front brake judder

Postby gismo » Fri Oct 19, 2007 2:02 pm

Does anybody else have this problem?
I've checked and I'm sure the disc isn't cracked or buckled. But I have found recently that the front brake judders when applied.
There's no unsettling noise just slight juddering.
They seem to work fine.

Any suggestions or advice would be welcome

Kind regards

Gismo
If you're not living on the edge then you're taking up too much space
Top
User avatar
andrew s
Member
Posts: 1264
Joined: Wed Feb 18, 2004 10:33 am
Location: Fife Scotland

Postby andrew s » Fri Oct 19, 2007 2:51 pm

If the disc is not warpped then the calipers might need a good cleaning to get rid of old brake dust.

Andrew :roll:
A man can fall many times in life but is never a failure until he refuses to get up
Top
User avatar
Paul
Wanna buy a sticker mister?
Posts: 2888
Joined: Mon Feb 16, 2004 8:44 pm
Location: Boxertrix Towers, Norfolk
Contact:
Contact Paul

Postby Paul » Fri Oct 19, 2007 3:36 pm

Hi Gismo,

Check to see if the disc rotor moves when you tug it laterally. Could be the wheel posts wearing down... You can solve that problem by fitting some BMW wavey washers.

Cheers,

Paul
You really need only two tools: WD-40 and duct tape. If it doesn't move and it should, use WD-40. If it moves and shouldn't, use the tape.
Top
User avatar
Jason M
Posts: 1404
Joined: Wed Feb 18, 2004 7:56 am
Location: southampton

Postby Jason M » Mon Oct 22, 2007 7:18 am

I'll go for the pistons meself. Last year my S only just went through the MOT on what he said was warped disks. There was a fair bit of judder, and coming to a stop slowly became a right mare. I thought it was the disks even though I'd changed them for some 2nd hand ones. Later I saw that the pads were wearing slightly wrong with the bottom pistons obviously not working as well as the top. The pads were wearing at an angle. I bought a new set of pistons and seals, fitted them which is a pretty straight forward job, now they're fine and no juddering. Cost me about 120 quid I think

Jason
2002 Black GSA (for random fault analysis and for stealing all my weekends fixing the b'stard)
2000 Black R1100S (for remembering the good old times)
Top
Post Reply

Return to “Boxertech”

Who is online

Users browsing this forum: No registered users and 113 guests