Page 1 of 1
Exhaust refinishing
Posted: Sat Aug 10, 2013 9:22 pm
by bikesnbones
Anyone here had any experience of powder coating exhausts ?
Is it even possible ?
Posted: Sat Aug 10, 2013 9:28 pm
by Boxered
Not sure about powder coating, but this company in Warrington does ceramic coating
http://camcoat.com/main/site/
Steve
Posted: Sun Aug 11, 2013 3:05 am
by bikesnbones
Thanks.
Probably very expensive but I'll look into it.
Posted: Sun Aug 11, 2013 10:25 am
by tanneman
Generally they don't ceramic coat used exhaust systems because they cannot guarantee the finish.
Posted: Sun Aug 11, 2013 12:21 pm
by dave the german
Calling daveg2812 to the forum - dave had his coated. Have a look at the results. He did have pics up
Posted: Sun Aug 11, 2013 4:28 pm
by adrianw
http://www.zircotec.com/
A friend of mine just got his TERMIGNONIs done on his 916SPS
The company is a spinoff from the nuclear industry.
Good for up to 900 degrees.
Adrian
Posted: Thu Aug 15, 2013 11:47 am
by Daveg2812
Mine were done at Camcoat in Warrington using their Cermakrome product.
And on the bike,
Bike's not had a lot of use this year but the finish is still pretty much the same. Cost about £150 (ish) with carriage.
Posted: Fri Aug 16, 2013 3:06 pm
by oyster
Mine looked just like Dave's when I had then ceramic coated. Cerachrome outside, black ceramic inside. On used pipes. They got sandblasted before the coating. Now, the finish is like dull alloy, old Triumph or Norton cases.
