R1200S Misfire troubleshooting - Bristol

Got a technical query? Found another 0.02bhp? Ask/tell the world.

Moderators: Gromit, Paul, slparry

Keith_P
Posts: 24
Joined: Wed Mar 31, 2021 8:24 pm
Location: Bristol

R1200S Misfire troubleshooting - Bristol

Postby Keith_P » Mon May 23, 2022 7:53 pm

2 plugs per cylinder is a bit of a pain to diagnose when you've got a misfire! Thought I'd sorted it with new plugs - possibly only one needed - but it's back after 1 ride, so I'm thinking coil pack... It's only done 11500mls, so can it really have a failure(s)? I'd like to find a local repair place to do swapsies before I shell out on what would have to be 2 x lower & one upper coil pack!
Oh, yes, the injectors are squirting ok and I've got what look like good sparks in fresh air...
'18 939 Hypermotard
'06 R1200S

Humbug
Member
Posts: 656
Joined: Wed Oct 28, 2015 6:06 pm
Location: Nottinghamshire

Re: R1200S Misfire troubleshooting - Bristol

Postby Humbug » Tue May 24, 2022 5:30 am

You can isolate the coil by unplugging them in turn. The bike will still run with one spark missing but not two. Pull a coil and start the bike, If it runs, the coil you have pulled is bad. If it doesn't run, its one of the other coils. Yes, it can happen at that mileage. Another issue that will cause the bike to cut out is the valve adjustment. If the bike cuts out or runs badly at idle it could be that they need checking.
11 plate KTM SMT

Keith_P
Posts: 24
Joined: Wed Mar 31, 2021 8:24 pm
Location: Bristol

Re: R1200S Misfire troubleshooting - Bristol

Postby Keith_P » Tue May 24, 2022 6:41 am

Thanks Humbug. Yes, I wasn't thinking clearly about the 2 plugs per cylinder being harder than one! Valve clearances are ok - the misfire is very abrupt, hence my strong feeling that it's electrical. Will also check all earthing points for corrosion, especially the ECU.
'18 939 Hypermotard
'06 R1200S

User avatar
ianbcr
Member
Posts: 1474
Joined: Wed Mar 19, 2008 6:40 pm
Location: Walsall

Re: R1200S Misfire troubleshooting - Bristol

Postby ianbcr » Tue May 24, 2022 8:38 pm

Usually a bad earth gives you the symptons of a flat battery and just get a clicking from the starter button. Had this with the bcr but ran fine from a bump start but cleaning the earth to frame cured the clicking and all back to normal.
Your born with a certain amout of heart beats, Dont waste them on exersise. [smilie=rooster.gif]


04 boxer cup rep. Gone but not forgoten
99 tlr1000 (V twin) tricked.
Indian Roadmaster Elite
Mercedes EQC 400

Keith_P
Posts: 24
Joined: Wed Mar 31, 2021 8:24 pm
Location: Bristol

Re: R1200S Misfire troubleshooting - Bristol

Postby Keith_P » Tue May 24, 2022 9:01 pm

Thanks - right on track as I'm getting that first stab click from the starter, then all ok on the second go (new battery made no difference).
I started up with 1 plug per side this evening, then the other two plugs and it's running perfectly like that and (not surprisingly) with all 4.
Earth connection now #1 culprit, especially as this bike had a load of corrosion evident when I bought it...
'18 939 Hypermotard
'06 R1200S

Keith_P
Posts: 24
Joined: Wed Mar 31, 2021 8:24 pm
Location: Bristol

Re: R1200S Misfire troubleshooting - Bristol

Postby Keith_P » Fri May 27, 2022 3:38 pm

Well, the main earth point was a challenge to 'service' without removing the tank! Good enough tho' until I have it all apart one day. Definitely improved matters - fingers crossed that my misfires have gone...
Thanks for the suggestions
'18 939 Hypermotard
'06 R1200S


Return to “Boxertech”

Who is online

Users browsing this forum: No registered users and 93 guests