cbr1200xx
Moderators: Gromit, Paul, slparry
cbr1200xx
Its a bit tatty round teh edges but so am I.
Intending to sort it over Winter.
Had a quick check o dyno run today and its putting out 173.17 bhp at rear wheel, about 6 down on quoted. Considering its on old fuel and hasnt had a service for a while its about on the money.
Guy reckons it could do with valve clearances doing and maybe plugs and filter.
1997 CBR1100XXV
1999 CBR1100XX
2009 HP2 Sport
2006 R1200s
2013 R1200RT anniversary
1999 CBR1100XX
2009 HP2 Sport
2006 R1200s
2013 R1200RT anniversary
- throttlemeister
- Posts: 1023
- Joined: Sun Sep 24, 2006 9:35 pm
- Location: Netherlands
- Contact:
Stock Blackbirds generally make 135-140 at teh wheel unless power commander cans and filter are fitted, then close to 150
This is a V&M cbr 1200
CArillo conrods, 13 to 1 compression, different cams, 1200cc, full akra etc etc
Only 25 were made of a planned 50, for teh Honda 50th anniversary in 1998. Crank power is 200 bhp or there abouts
This is a V&M cbr 1200
CArillo conrods, 13 to 1 compression, different cams, 1200cc, full akra etc etc
Only 25 were made of a planned 50, for teh Honda 50th anniversary in 1998. Crank power is 200 bhp or there abouts
1997 CBR1100XXV
1999 CBR1100XX
2009 HP2 Sport
2006 R1200s
2013 R1200RT anniversary
1999 CBR1100XX
2009 HP2 Sport
2006 R1200s
2013 R1200RT anniversary
- throttlemeister
- Posts: 1023
- Joined: Sun Sep 24, 2006 9:35 pm
- Location: Netherlands
- Contact:
PBBoxer wrote:No probs
Stoney has just had a go.
Needs fettling though, its a bit untidy.
Hesitant ot constant throttle sometimes too, needs setting up
Sounds like the carbs may need balancing - I recently balanced mine, which stopped the very slight 'hunting' just above idle in low gears/low engine load. Runs perefectly now.
How many miles has yours done?
Blackbird has gone in today to my mates place for:
Removal of foks, re chrome, polish lowers and fit internal ohlins
swing arm off for polish and or clean, replace penske spring
engine covers off for re paint
valve clearances, dyno time for setup
serice
In teh meantime i have all teh bodywork and im going to try and get that sorted
Removal of foks, re chrome, polish lowers and fit internal ohlins
swing arm off for polish and or clean, replace penske spring
engine covers off for re paint
valve clearances, dyno time for setup
serice
In teh meantime i have all teh bodywork and im going to try and get that sorted
1997 CBR1100XXV
1999 CBR1100XX
2009 HP2 Sport
2006 R1200s
2013 R1200RT anniversary
1999 CBR1100XX
2009 HP2 Sport
2006 R1200s
2013 R1200RT anniversary
- Boxadog 2000
- Member
- Posts: 1908
- Joined: Wed Feb 18, 2004 8:29 pm
- Location: Looking over hedges
Return to “My other bike's a...”
Who is online
Users browsing this forum: No registered users and 95 guests